AUTOUTLETP6100 Universal Oscilloscope Probe with Accessories Kit 100MHz Oscilloscope Clip Probes with BNC to Minigrabber Test Lead Kit

Will be buying more for other instruments, they work well. GET the longest ones available (6'). 4-foot ones are short for most instruments.

They arrived on time and they were actually a lot more sturdy and well built than what I was expecting so

I ordered these probes as to replace and be a back up for my factory BK Precision probes after one of the 1X/10X nubs came off one of my probes.What is good about these probes is the hook clips and alligator ground clip have good tension on them. The slide switch to change from 1X to 10X has a positive click and feel to it.What could be improved is the the part that covers the compensation screw slips around so I twisted the cover into position to allow the compensation tool to have a direct path to the screw. The compensation screws were easier adjusted using a 1/16" blade mini screwdriver. The plastic dual bladed (flat on one side, cross blade, not a Phillips head, on the other) compensation adjustment tool didn't grip securely and the tips became damaged.I had a slight leading edge rise I tried to flatten out but couldn't get it flattened out so after awhile I resorted to using my mini screwdriver to compensate Channel Two probe. Which I will use from now on.The BNC connections aren't as tight as my factory probe and the factory probes collars around the compensation screws had no play whatsoever.For the money, don't expect the "feel" of factory supplied probes.

Everything was as described

I must admit, I wasn't expecting a lot, given the low cost, but I stand corrected. The probes came with the expected accessories, and trimming them to achieve children square wave reproduction was smooth, without glitching.

These are working great so far. They arrived quick also.

Not bad

I have an older Tektronix oscilloscope which needed new probes as the older ones were creating noise and I did not want to spend over a $100 bucks for a new Tektronics set so I deceded on this set.I have not had these probes very long but so far I am pleased with this set, as it turned out it is a great bargin at this price and it is a 1X/10X probe. Great flexibilty, strong clips for grabing the componet leads firmly and strong bond between the connectors and wire.

They work, and seem to do their job properly. I bought them alongside a Hantek DSO2C10 oscilloscope. Though I have not the means to drive them at 100MHz at the moment, for PWM and music synth investigation they've been decently accurate.Good set of cost effective probes.

as it says on the box what more can I say

I am a retired electronics service technician, I used to pay hundreds of dollar to get one test probe, therefore when I saw its price, I couldn't believe my eyes, after I received them and use them, I would highly recommend this product.

Wanted new probes for my overhauled Tek. Happy with them. Compensation works fine but dont forget to check the range for your scope. Cheap enough to carry a spare if they break.It seems all these Chinese probes are actually all made by the same factory - just the branding changes.

When I received the probes I thought they looked ok. One probe's 1X/10X slide switch would not move and stuck on 1X. I started using them and one was hooked up to my frequency HP counter. The probe started to smoke. I was aligning a CB radio IF frequencies. So I don't know what to say. Yes I'm dissappointed. I ended up buying replacement probes from an electronics supplier.